What P0167 means
Sensor 3 on bank 2 is a switching oxygen sensor behind a second converter or converter brick.
How the engine computer detects it
It is rare – documented for Jaguar Land Rover's supercharged V6 and V8 (2013–2016), where it is the 'post-cat' sensor of the second bank, and for Ford systems that monitor part of the converter volume. P0167 concerns its heater. Ford checks the driver voltage continuously and the heater current once per drive cycle when the sensor is estimated above about 120 °C (248 °F) and has heated for 30 s; below 0.22–0.55 A (depending on sensor type) or above 3 A is a fault, and the heater resistance has its own code (P0061). Jaguar Land Rover lists P0167 for its post-cat sensor of the second bank. A cold sensor can lead to P0165/P0166. When it fails, the downstream evaluation of that converter is suspended; there is no limp mode.
Written from public technical sources and not yet checked by a mechanic. How we write these pages
Symptoms
- Check engine light on (usually after two drive cycles)
- P0165/P0166 may follow
- Usually no noticeable change in driving
Common causes
- Heater element burnt out Most likely
- Heater wiring, connector or fuse Possible
- Short circuit (current above 3 A) Less likely
- Engine module driver or software (Jaguar Land Rover) Less likely
How to diagnose P0167
- Read every stored code with an OBD-II scanner. If misfire or fuel trim codes are there too, fix those first: they often cause this one.
- Inspect the parts involved: oxygen sensor heater bank2 sensor3, oxygen sensor heater circuit, fuses.
- Work through the causes above from most to least likely, cheapest checks first.
- Clear the code and drive a full drive cycle to confirm the repair held.
Reading the code
- P
- Powertrain
- 0
- Generic (SAE) code
- 1
- Fuel and air metering
- 67
- Specific fault
Questions drivers ask
Can I drive with code P0167?
Usually yes for a short time, if the car drives normally, the temperature gauge reads normal and the check engine light is steady. If the light flashes, the engine loses power or overheats, or other warning lights come on, pull over and have it checked.
Will my car pass an emissions inspection with P0167?
Probably not in states that test vehicles with an OBD-II scan: an emissions-related code that keeps the check engine light on is usually an automatic fail. Rules differ by state and county, so check yours.
Will P0167 clear by itself?
The light can go off after several drive cycles without the fault, but the code returns if the cause is still there. After a repair, the readiness monitors need a full drive cycle before an inspection.
Can I fix P0167 myself?
Often yes, with an OBD-II scanner and basic tools. Difficulty: easy. Start with the cheapest checks before replacing expensive parts.
This page is general information, not a substitute for a professional diagnosis. Repair costs are rough estimates for parts and labor and vary by vehicle and region.